No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring iPCA to Implement Device-Level Packet Loss Measurement

Configuring iPCA to Implement Device-Level Packet Loss Measurement

Pre-configuration Tasks

After device-level packet loss measurement is configured on a device, iPCA can measure the number of packets and packet loss ratio for a direct link or a device.

Before configuring iPCA to implement device-level packet loss measurement, complete the following tasks:
  • Configure static routes or routing protocols to ensure network connectivity between devices. For details, see S12700 V200R011C10 Configuration Guide - IP Unicast Routing.
  • Configure NTP to implement time synchronization between the devices. For details, see NTP Configuration in the S12700 V200R011C10 Configuration Guide - Device Management.

Configuration Procedure

Configuring iPCA to Implement Packet Loss Measurement on a Device and Configuring iPCA to Implement Packet Loss Measurement on a Direct Link can be performed in any sequence. You can select one of them or both of them according to your needs.

Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 150078

Downloads: 56

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next