No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LSP Ping Test

LSP Ping Test

The NQA label-switched paths (LSP) ping test checks the reachability of Label Distribution Protocol (LDP) LSPs or traffic engineering (TE) LSPs.

Figure 6-12 shows the process of an LSP ping test:

  1. The source (PE-A) constructs a Multiprotocol Label Switching (MPLS) Echo Request packet whose destination IP field is an IP address on the address block 127.0.0.0/8. The source then searches for the corresponding Label Distribution Protocol (LDP) LSP based on the configured remote label switching router (LSR) ID. The source forwards the packet through that LDP LSP in the MPLS domain. For a TE LSP, the packet can be sent from a tunnel interface and then forwarded along a specified constraint-based routed LSP (CR-LSP).

  2. The destination (PE-B) egress monitors port 3503 and sends an MPLS Echo Reply packet to the source.

  3. The source receives the MPLS Echo Reply packet and calculates the time taken for communication between the source and the destination.
Figure 6-12  Network for LSP ping test

LSP ping test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 135654

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next