No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for NETCONF

Licensing Requirements and Limitations for NETCONF

Involved Network Elements

Table 14-6  Involved Network Elements
NETCONF mode Network management system
NETCONF over SSH Callhome

Huawei Agile Controller-Campus in V300R002C00 or a later version

NETCONF over SSH Third-party NMSs supporting the NETCONF over SSH mode

Licensing Requirements

NETCONF is a basic feature of a switch and is not under License control.

Version Requirements

Table 14-7  Products and versions supporting NETCONF

Series

Product

Software Version

S12700

S12708, S12712

V200R011C10

S12710

V200R011C10

S12704

V200R011C10

NOTE:
To know details about software mappings, see Hardware Query Tool.

Feature Limitations

  • After NETCONF is enabled, some functions must be configured on the NMS using NETCONF, but cannot be configured using command on the switch. If you configure these functions using command on the switch, the following message is displayed:
    Error: This command cannot be executed in netconf status.
  • After NETCONF is enabled, some functions can be configured using NETCONF on the NMS and using command on the switch. When you configure them using command on the switch, the following message is displayed. Continue the configuration after confirming that no conflict will occur.
    Warning: This command may cause confliction in netconf status. Continue? [Y/N]:
  • After NETCONF is enabled, some functions can be configured using NETCONF or SNMP on the NMS. Before configuring these functions, ensure that no conflict will occur.

  • After NETCONF is enabled, do not modify configuration files (including the new configuration file specified in the Bootload menu during switch restart) on switches or the configurations delivered by the NMS to switches. Otherwise, data in the NETCONF database and configuration files may be inconsistent and configurations may be lost.
  • If an error occurs in the NETCONF process of the switch, detailed error information of the process will be saved in the directory flash:/core_dump.

  • When the delete-config operation is performed on the NMS to clear configurations in the NETCONF database, the switch automatically runs the reset saved-configuration command to clear the next startup configuration file and cancel the configuration file used for next startup.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 142300

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next