No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for NQA

Licensing Requirements and Limitations for NQA

Involved Network Elements

Other network elements are not required.

Licensing Requirements

The NQA feature requires a License. The NQA commands can be run on any switch, but the NQA feature takes effect only when a License is loaded.

For details about how to apply for a license, see S Series Switch License Use Guide.

Version Requirements

Table 6-1  Products and versions supporting NQA


Product Model

Software Version


S12708, S12712

V200R005C00, V200R006C00, V200R007C00, V200R007C20, V200R008C00, V200R009C00, V200R010C00, V200R011C10


V200R010C00, V200R011C10


V200R008C00, V200R009C00, V200R010C00, V200R011C10

To know details about software mappings, see Hardware Query Tool.

Feature Limitations

  • If the number of running test instances reaches the maximum number supported by the system, the start command will fail.
  • If you need to run the start now command for a test instance again, ensure that the last operation has been complete.
  • If you specify that a test instance starts to run on schedule, ensure that the specified time is later than the current system time; otherwise, the configuration is invalid.
  • In V200R006 and earlier versions, X1E cards do not support PWE3 Ping and PWE3 Trace tests. In V200R005, X1E cards do not support LSP Ping, LSP Jitter, and LSP Trace tests.
  • SA series cards do not support LSP Ping, LSP Jitter, LSP Trace, PWE3 Ping, or PWE3 Trace test.
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 137328

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next