No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Switch to Communicate with an NMS by NETCONF over SSH Callhome Mode

Configuring a Switch to Communicate with an NMS by NETCONF over SSH Callhome Mode

Prerequisites

There is a reachable route between the switch and NMS.

Context

The switch actively sets up a NETCONF session with the NMS in NETCONF over SSH Call Home mode. Therefore, enable the NETCONF function on the switch, and set the IP address and port number of the communicating parties first.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run netconf

    NETCONF is enabled and the NETCONF view is displayed.

  3. Run source ip ip-address [ port port-number ]

    To configure the IP address and port number used by the switch to communicate with the NMS using NETCONF.

  4. Run callhome callhome-name

    A Call Home template is created and the Call Home template view is displayed.

  5. Run ip address ip-address port port-number

    To configure the IP address and port number used by the NMS to communicate with the switch using NETCONF.

Verifying the Configuration

Run the display netconf all command in any view to display the NETCONF configuration.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 136694

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next