No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring sFlow Agent and Collector Information

Configuring sFlow Agent and Collector Information

Context

The sFlow controller's address is the destination address of sFlow packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run sflow agent { ip [ vpn-instance vpn-instance-name ] ip-address | ipv6 [ vpn-instance vpn-instance-name ] ipv6-address }

    An IP address is configured for an sFlow agent.

    The specified IP address of an sFlow agent must be a valid unicast address that has been configured on the device interface. If an IPv6 address is specified, the IPv6 address must be a global unicast address, but not a link-local address. By default, the source IP address is the agent's outbound interface address in the route pointing to the collector.

    A maximum of two sFlow agents can be configured in the system. Each VPN instance of an address family supports only one agent.

  3. Run sflow collector collector-id { ip [ vpn-instance vpn-instance-name ] ip-address | ipv6 [ vpn-instance vpn-instance-name ] ipv6-address } [datagram-size datagram-size | port port-num | time-out time ] * [ description description ]

    Parameters are set for an sFlow collector.

    When creating an sFlow collector, specify the ID and IP address. If the aging time of the sFlow collector is not set, the sFlow collector is not aged out by default and the aging time cannot be changed. A maximum of two sFlow collectors can be configured in the system.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 141329

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next