No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Device to Send EAP Packets with a Code Number to 802.1X Users

(Optional) Configuring the Device to Send EAP Packets with a Code Number to 802.1X Users


When a non-Huawei device used as the RADIUS server sends RADIUS packets with attribute 61, EAP packet code number 0xa (hexadecimal notation, 10 in decimal notation), and data type being 0x19 (hexadecimal notation, 25 in decimal notation) to the device, run the dot1x eap-notify-packet command on the device so that the device can send EAP packets with code number 0xa and data type 0x19 to users. If the dot1x eap-notify-packet command is not executed, the device does not process EAP packets of this type and users may be disconnected.

Perform this configuration if the device connects to an H3C iMC RADIUS server. For other precautions about interoperability between the device and H3C iMC RADIUS server, see What Should I Be Aware of When Connecting the Device to an H3C iMC RADIUS Server?.


  1. Run system-view

    The system view is displayed.

  2. Run dot1x eap-notify-packet eap-code code-number data-type type-number

    The device is configured to send EAP packets with a code number to 802.1X users.

    By default, the device does not send EAP packets with a code number to 802.1X users.


    If an H3C iMC functions as the RADIUS server, run the dot1x eap-notify-packet eap-code 10 data-type 25 command on the device.

Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 131607

Downloads: 62

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next