No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing PPPoE Session Statistics

Clearing PPPoE Session Statistics

Context

Before collecting PPPoE session statistics, run the following commands in the user view to clear the existing statistics.

After service deployment is complete or a fault has been rectified, run the command to clear statistics, collect related statistics again, and then run command to check whether authentication works normally and whether packets are successfully sent and received.

User services are interrupted when PPPoE sessions are terminated; therefore, exercise caution when performing this operation.

Procedure

  • Run the reset ppp statistics command in the user view to clear PPP statistics.
  • Run the reset pppoe statistics command in the user view to clear PPPoE statistics.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 123287

Downloads: 59

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next