No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Traffic Identification Rules

Configuring Traffic Identification Rules


To implement destination-based accounting, the device must be able to identify the traffic destined for different networks according to access control lists (ACLs).


  1. Run system-view

    The system view is displayed.

  2. Configure traffic identification rules.

    1. Run acl [ number ] acl-number [ match-order { auto | config } ]

      An advanced ACL is created by using an ACL number and the advanced ACL view is displayed.

      Or run acl name acl-name { advance | acl-number } [ match-order { auto | config } ]

      An advanced ACL is created by using an ACL name and the advanced ACL view is displayed.

      By default, no ACL exists on the device.

    2. Run rule [ rule-id ] permit ip { source { source-ip-address { source-wildcard | src-netmask } | any } | destination { destination-ip-address { destination-wildcard | des-netmask } | any } } *

      An advanced ACL rule is created.

      By default, no ACL rule exists on the device.


    The number of an advanced ACL is in the range from 3000 to 3999.

    The destination address is mandatory and the source address is optional. You can configure both the source and destination addresses to precisely specify the traffic on which accounting is performed.

    If the any parameter is configured to specify all source and destination addresses, the traffic identification rule is invalid.

Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 123043

Downloads: 58

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next