No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring an Interface to Allow Only PPPoE Packets to Pass

(Optional) Configuring an Interface to Allow Only PPPoE Packets to Pass


To allow host users to access the network using only PPPoE, you can configure the user-side interface on the switch between the PPPoE server and user hosts to allow only PPPoE packets from a specified user to pass. The interface then discards other types of packets from the user and all types of packets from other users.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    An interface is created and the interface view is displayed.

  3. Run traffic-pppoe { any | source-address } { any | destination-address }

    The interface is configured to allow only PPPoE packets to pass.

    By default, an interface allows all packets to pass.

Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 117728

Downloads: 55

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next