No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NAC Common Mode

Configuring the NAC Common Mode

Context

NAC supports the common configuration mode and unified configuration mode. Before configuring NAC functions in the common mode, you must switch the NAC configuration mode to common mode.

NOTE:
  • After the common mode and unified mode are switched, you must restart the device to make each function in the new configuration mode take effect.
  • In the unified mode, only the commands of the common mode are unavailable; in the common mode, only the commands of the unified mode are unavailable. In addition, after the configuration mode is switched, the commands supported by both the common mode and unified mode still take effect.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run undo authentication unified-mode

    The NAC mode is switched to common mode.

    By default, the unified NAC configuration mode is used.

    NOTE:

    After SVF is enabled in unified mode, the device cannot switch to common mode.

Verifying the Configuration

  • Run the display authentication mode command to check the current NAC configuration mode and the mode after restart.
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 119012

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next