No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - User Access and Authentication

This document describes the working mechanisms, configuration procedures, and configuration examples of User Access and Authentication features, such as AAA, DAA, NAC, PPPoE, Policy Association, and IP session.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Static Users

(Optional) Configuring Static Users

Context

In network deployment, static IP addresses are assigned to dumb terminals such as printers and servers. These users can be configured as static users for flexible authentication.

After static users are configured, the device can use static user information such as their IP addresses as the user names to authenticate the users only if one of the 802.1X authentication, MAC address authentication, and Portal authentication modes is enabled on the interfaces connected to the static users.

NOTE:

After static users are configured, the device first uses the static user names and passwords to authenticate the users. If the authentication fails, the device can perform Portal authentication on the users.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run static-user start-ip-address [ end-ip-address ] [ vpn-instance vpn-instance-name ] [ domain-name domain-name | interface interface-type interface-number [ detect ] | mac-address mac-address | vlan vlan-id ] *

    The static user is configured.

    By default, no static user is configured.

    NOTE:

    Only Layer 2 Ethernet interfaces and Layer 2 Eth-Trunk interfaces can be configured as static user interfaces. If an interface is added to an Eth-Trunk or switched to a Layer 3 interface, the static user function does not take effect.

    When the interface (interface interface-type interface-number) mapping static users is specified, the VLAN (vlan vlan-id) that the interface belongs to must be configured.

  3. Run static-user username format-include { ip-address | mac-address | system-name }

    The static user name for authentication is set.

    By default, the name of a static user consists of system-name and ip-address.

  4. Run static-user password cipher password

    The static user password for authentication is set.

    By default, the password of a static user is vlan.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178117

Views: 119379

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next