No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the HVPN Configuration

Verifying the HVPN Configuration

Context

After you configure a hierarchical virtual private network (HVPN), you can view on a local customer edge device (CE) the default route or specific routes from this CE to a remote CE.

Procedure

  • Run the display ip routing-table command on a local CE to check routing table information.

    • If you have configured an HoVPN, the command output shows a default route from the local CE to the remote CE. The next hop of the route is a user-end provider edge device (UPE).

    • If you have configured an H-VPN, the command output shows specific routes from the local CE to the remote CE.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 157029

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next