No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding a VSI to the L2VE Interface

Binding a VSI to the L2VE Interface


Perform the following steps on an NPE.


  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-ethernet ve-number.subnumber

    The L2VE sub-interface view is displayed.

  3. Run dot1q termination vid vlan-id

    A VLAN ID is configured for the L2VE sub-interface.

  4. Run l2 binding vsi vsi-name

    The L2VE interface is bound to a VSI.

Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158037

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next