No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an L3VE Interface

Creating an L3VE Interface

Context

Perform the following steps on an NPE.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface virtual-ethernet ve-number

    A VE interface is created and the VE interface view is displayed.

  3. Run ve-group ve-group-id l3-access

    The VE interface is configured as an L3VE interface that accesses the L3VPN and is bound to a VE group.

    NOTE:

    The L2VPN can be configured to access the L3VPN only if the L2VE and L3VE interfaces are bound to the same VE group and the L2VE and L3VE interfaces are on the same card.

    After a VE interface is bound to a VE group, you are advised to run the load-distribution mode slot slot-id enhanced command to set the load balancing mode of an HG trunk to enhanced. Otherwise, traffic transmitted between two cards may fail to be load balanced in an HG trunk, causing inter-card packet loss.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 165327

Downloads: 168

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next