No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring All Client PEs to Establish IBGP Connections with the RR

Configuring All Client PEs to Establish IBGP Connections with the RR


You can configure a PE to establish an MP-IBGP peer relationship with an RR. In this manner, the RR reflects VPNv6 routes for the PE.

Perform the following steps on all Client PEs.


  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number

    The RR is specified as the BGP peer.

  4. Run peer ipv4-address connect-interface interface-type interface-number

    The interface is specified as an interface to establish the TCP connection.

  5. Run ipv6-family vpnv6

    The BGP VPNv6 address family view is displayed.

  6. Run peer ipv4-address enable

    The capability of exchanging IPv6 VPN routes between the Client PE and the RR is enabled.

Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 165750

Downloads: 169

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next