No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-EBGP Between ASBRs in Different ASs

Configuring MP-EBGP Between ASBRs in Different ASs

Context

In inter-AS VPN Option B, you need not create VPN instances on ASBRs. The ASBR does not filter the VPNv4 routes received from the PE in the same AS based on VPN targets. Instead, it advertises the received VPNv4 routes to the peer ASBR through MP-EBGP.

In the switch, an ASBR can only change the next-hop address of a VPNv4 route to the ASBR's address before advertising the route to a PE.

Perform the following steps on the ASBR.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface connected with the ASBR interface is displayed.

  3. Run ip address ip-address { mask | mask-length }

    The interface IP address is configured.

  4. Run mpls

    The MPLS capability is enabled.

  5. Run quit

    Return to the system view.

  6. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  7. Run peer ipv4-address as-number as-number

    The peer ASBR is specified as the EBGP peer.

  8. (Optional) Run peer { ipv4-address | group-name } ebgp-max-hop [ hop-count ]

    The maximum number of hops is configured for the EBGP connection.

    Generally, one or more directly connected physical links exist between EBGP peers. If the directly connected physical link(s) are not available, run this command to ensure that the TCP connection can be set up between the EBGP peers through multiple hops.

  9. Run ipv4-family vpnv4 [ unicast ]

    The BGP-VPNv4 address family is displayed.

  10. Run peer ipv4-address enable

    The exchange of IPv4 VPN routes with the peer ASBR is enabled.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 159694

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next