No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding the VSI of the SPE with the VLL

Binding the VSI of the SPE with the VLL


This part describes how to configure an SPE to establish VSI peer relationships with other SPEs, and with UPEs.

Do as follows on the SPE devices:


  1. Run system-view

    The system view is displayed.

  2. Run vsi vsi-name static

    The VSI view is created and the static member discovery is enabled.

  3. Run pwsignal ldp

    The LDP is specified as the PW signaling protocol and the VSI LDP view is displayed.

  4. Run vsi-id vsi-id

    The VSI ID is configured.

  5. Run mac-withdraw enable

    After the configuration, when an AC fault or a UPE fault occurs and the VSI remains Up, the local MAC address is deleted and all the remote peers are informed of the deletion.

    This command takes effect only after the interface-status-change mac-withdraw enable command is also used.

  6. Run peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]

    The VSI peer is configured.

  7. Run peer peer-address [ tnl-policy policy-name ] static-upe trans transmit-label recv receive-label

    The received and sent labels between the SPE and the static UPE are configured.

    The label trans here must be the same as the label receive-vpn-label that is configured on UPE. In addition, the label recv must be the same as the label transmit-vpn-label that is configured on UPE.

Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 159053

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next