No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring MP-IBGP Between PEs and ASBRs in the Same AS

Configuring MP-IBGP Between PEs and ASBRs in the Same AS

Context

Perform the following steps on the PE and ASBR in the same AS.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer ipv4-address as-number as-number

    The peer ASBR is specified as the IBGP peer.

  4. Run peer ipv4-address connect-interface loopback interface-number

    The address of the loopback interface is specified as the source address of the BGP session.

  5. Run ipv6-family vpnv6

    The BGP IPv6 VPN address family view is displayed.

  6. Run peer ipv4-address enable

    The exchange of VPN-IPv6 routes with the peer PE or the ASBR is enabled.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158538

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next