No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Kompella VLL Configuration

Verifying the Kompella VLL Configuration


After configuring Kompella VLL successfully, you can check BGP information, connection, and VPN target list of Kompella VLL and L2VPN information on the PE device.


  • Run the display bgp l2vpn { all | group [ group-name ] | peer [ [ peer-ip-address ] verbose ] | route-distinguisher route-distinguisher [ ce-id ce-id [ label-offset label-offset ] ] } command to check the BGP information of the Kompella VLL.
  • Run the display mpls l2vpn connection [ vpn-name [ remote-ce ce-id | down | up | verbose ] | summary | interface interface-type interface-number ] command to check information about the connection in Kompella mode.
  • Run the display mpls l2vpn [ l2vpn-name [ local-ce | remote-ce ] ] command to check the VLL information on the PE.
  • Run the display mpls l2vpn { export-route-target-list | import-route-target-list } command to check the VPN target list of the Kompella VLL.
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158278

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next