No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for PWE3

Licensing Requirements and Limitations for PWE3

Involved Network Elements

Other network elements are not required.

License Requirements

You can use the PWE3 feature only after the MPLS function is enabled. The MPLS function is controlled by a license. By default, MPLS is disabled on a new device. To use the MPLS function, apply for and purchase the license from the equipment supplier.

Version Requirements

Table 6-2  Products and versions supporting PWE3

Product

Product Model

Software Version

S12700

S12708, S12712

V200R005C00, V200R006C00, V200R007C00, V200R007C20, V200R008C00, V200R009C00, V200R010C00, V200R011C10

S12710

V200R010C00, V200R011C10

S12704

V200R008C00, V200R009C00, V200R010C00, V200R011C10

NOTE:
To know details about software mappings, see Hardware Query Tool.

Feature Limitations

  • The SA series cards do not support PWE3.

    In V200R006 and earlier versions, the X1E series cards do not support PWE3.

    The XGE interface connected to ACU2, ET1D2IPS0S00, ET1D2FW00S00, ET1D2FW00S01, or ET1D2FW00S02 card does not support the PWE3 function.

  • For E series cards, do not add the PW to VLAN 1. If the PW is added to VLAN 1, the AC joins VLAN 1 in untagged mode and VLAN tags of packets are removed.

  • By default, link type negotiation is enabled globally on the device. If a VLANIF interface is used as an AC-side interface for PWE3, the configuration conflicts with link type negotiation. In this case, run the lnp disable command in the system view to disable link type negotiation.

  • If L2VPN is configured on the device, the AC-side outbound interface does not support IP address-based load balancing when the interface is an Eth-Trunk interface.
  • If the PW-side interface is a Layer 3 interface switched by the undo portswitch command, the AC-side interface cannot be a Layer 3 interface or subinterface belonging to a Layer 3 interface; otherwise, traffic forwarding is abnormal.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158610

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next