No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Static BFD for PWs

Configuring Static BFD for PWs

Static BFD for PWs enables the device to fast detect faults on PWs and trigger switching of upper-layer applications. Static BFD applies to small-scale networks.

Pre-configuration Tasks

Before configuring static BFD for PWs, complete the following tasks:

  • Set IP parameters to make each node reachable.

  • Configure a PW.

Configuration Procedure

The following configurations are mandatory and must be performed in sequence.
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158525

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next