No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MPLS L2VPN

Enabling MPLS L2VPN

Context

Before configuring a PW, you must enable MPLS L2VPN.

Perform the following operations on the PEs or UPEs at both ends of a PW.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mpls l2vpn

    MPLS L2VPN is enabled.

    NOTE:

    If the non-Huawei device does not have the capability of processing L2VPN label requests, you need to run the mpls l2vpn no-request-message command on the Huawei device to enable the two devices to communicate.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 159632

Downloads: 159

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next