No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the VLL FRR Configuration

Verifying the VLL FRR Configuration

Context

After configuring VLL FRR, you can check information about local and remote PWs, BFD sessions, and L2VPN forwarding. You can also run the manual-set pw-ac-fault command to set faults on a PW to verify whether the switchover between the primary and secondary PWs is normal.

Procedure

  • Run the manual-set pw-ac-fault command on the primary PW to simulate a fault to verify whether the switchover between the primary and secondary PWs is working normally.
  • Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command to check information about the local end of the Martini VC.
  • Run the display mpls l2vc remote-info [ vc-id ] command to check information about the remote end of the Martini VC.
  • Run the display bfd session pw interface interface-type interface-number [ secondary ] [ verbose ] command to check information about the BFD session.
  • Run the display mpls l2vpn connection [ vpn-name [ remote-ce ce-id | down | up | verbose ] | summary | interface interface-type interface-number ] command to check information about the Kompella VLL.
  • Run the display mpls l2vpn forwarding-info [ vc-label ] interface interface-type interface-number command to check forwarding information about the L2VPN.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 157754

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next