No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Collecting VPLS Traffic Statistics

Collecting VPLS Traffic Statistics

Context

To collect statistics on VPLS traffic, choose either of the following methods:
  • Enable traffic statistics collection for the specified PW.
  • Enable traffic statistics collection on the VLANIF interfaces bound to the specified VPLSs.

Do as follows on the device configured with the VSI:

Procedure

  • Enable traffic statistics collection for the specified PW.
    1. Run the system-view command to enter the system view.
    2. Run the vsi vsi-name [ auto | static ] command to enter the VSI view.
    3. Choose one of the following commands to collect statistics on traffic of a PW:
      • In BGP mode:
        1. Run the pwsignal bgp command to configure BGP as the PW signaling protocol and enter the VSI-BGP view.
        2. Run the traffic-statistics peer peer-address remote-site site-id enable command to enable the traffic statistics function on a Kompella VPLS PW.
      • In LDP mode:
        1. Run the pwsignal ldp command to configure LDP as the PW signaling protocol and enter the VSI-LDP view.
        2. Run the traffic-statistics peer peer-address peer-address [ negotiation-vc-id vc-id ] enable command to enable the traffic statistics function on a Martini VPLS PW.
          NOTE:

          When there are a large number of PWs, you can run the traffic-statistics enable (VSI-LDP view) command to enable the traffic statistics function on a Martini VPLS PW.

      • In BGP AD mode:
        1. Run the bgp-ad command to set the PW establish mode of the VSI to automatic discovery and deployment, and enter the VSI-BGPAD view.
        2. Run the traffic-statistics peer peer-address enable command to enable the traffic statistics function on a BGP AD VPLS PW.
          NOTE:

          When there are a large number of PWs, you can run the traffic-statistics enable (VSI-BGPAD view) command to enable the traffic statistics function on all BGP AD VPLS PWs.

  • Enable traffic statistics collection on the VLANIF interfaces bound to the specified VPLS.
    1. Run the system-view command to enter the system view.
    2. Run the interface vlanif vlan-id command to enter the VLANIF interface view.
    3. Run the l2 binding vsi vsi-name command to bind the VLANIF interface to a VSI.
    4. Run the statistic enable { both | inbound | outbound } command to enable traffic statistics collection on the VLANIF interface bound to the specified VSI.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 157919

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next