No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Kompella VPLS Configuration

Verifying the Kompella VPLS Configuration

Prerequisites

All Kompella VPLS configurations are complete.

Procedure

  • Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a VPLS VSI.
  • Run the display vsi name vsi-name statistics command to check information about VSI statistics, including the PW and AC status.
  • Run the display l2vpn ccc-interface vc-type { all | vc-type } [ down | up ] command to check information about the interface used by an L2VPN connection.
  • Run the display vsi remote bgp [ nexthop nexthop-address [ export-vpn-target vpn-target ] | route-distinguisher route-distinguisher ] command to check information about a remote VSI.
  • Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command to check information about a VPLS connection.
  • Run the display vpls forwarding-info [ vsi vsi-name [ peer peer-address [ negotiation-vc-id vc-id | remote-site site-id ] ] | state { up | down } ] [ verbose ] command to check forwarding information of all VSIs.
  • Run the display vsi services { all | vsi-name | interface interface-type interface-number | vlan vlan-id } command to check information about the AC interface associated with the VSI.
Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 158071

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next