No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring LDP HVPLS

Configuring LDP HVPLS

Pre-configuration Task

If there are a large number of VPLS PEs, you can use the HVPLS networking scheme to reduce the performance requirements on PEs.

Before configuring LDP HVPLS, complete the following tasks:
  • Configure LSR IDs on the UPE and SPE.
  • Enable MPLS and MPLS LDP on the UPE and SPE.
  • Enable MPLS L2VPN on the UPE and SPE.
NOTE:

Kompella VPLS uses BGP as the signaling. Configuring an RR can solve the problem of excessive connections caused by VPLS full connections. Therefore, the switch supports only Martini HVPLS.

Configuration Procedure

To configure LDP HVPLS, configure the UPE and SPE.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 165607

Downloads: 169

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next