No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - VPN

This document describes the VPN configuration procedures and provides configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Upper and Lower Alarm Thresholds for VPLS VCs

Configuring the Upper and Lower Alarm Thresholds for VPLS VCs

Context

A device supports only a limited number of VPLS VCs. After the total number of VPLS VCs created on a device exceeds a certain limit, the device performance deteriorates. To prevent device performance deterioration caused by excessive VPLS VCs, configure the upper and lower alarm thresholds for VPLS VCs. You can flexibly adjust the upper and lower alarm thresholds for VPLS VCs based on actual requirements.

Procedure

  1. Run the system-view command to enter the system view.
  2. Run the mpls l2vpn command to enter the MPLS L2VPN view.
  3. Run the mpls l2vpn vsi-pw limit threshold-alarm upper-limit upper-limit-value lower-limit lower-limit-value command to configure the upper and lower alarm thresholds for VPLS VCs.

    By default, the upper and lower alarm thresholds are 80% and 70% respectively.

    • upper-limit-value specifies the upper alarm threshold for VPLS VCs. If the proportion of VPLS VCs created to the maximum VPLS VCs allowed reaches this threshold, a VPLS VC threshold-crossing alarm is reported.
    • lower-limit-value specifies the lower alarm threshold for VPLS VCs. If the proportion of VPLS VCs created to the maximum VPLS VCs allowed falls below this threshold, a VPLS VC threshold-crossing clear alarm is reported.
    • upper-limit-value must be greater than lower-limit-value.

Translation
Download
Updated: 2019-04-01

Document ID: EDOC1000178118

Views: 156836

Downloads: 157

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next