No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Basic Configuration

S1720, S2700, S5700, and S6720 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to the Device Through the Web System for the First Time (Switches Changed to the Cloud-based Management Mode)

Logging In to the Device Through the Web System for the First Time (Switches Changed to the Cloud-based Management Mode)


After a device is changed to the cloud-based management mode, you can log in to the device through the Web system for the first time. After logging in to the device, you can easily configure the web login function on the device and then maintain the device in cloud-based management mode on the web page.

Pre-configuration Tasks

Before logging in to a device for the first time through the Web system, complete the following tasks:

  • Power on the device.
  • Ensure that the device has been changed to the cloud-based management mode.

Default Settings

Table 5-7  Default settings of the device
Parameter Default Setting
User name admin
User level 15
Login IP address


  1. Connect the PC to the device.

    If the device works in cloud-based management mode, you need to connect the PC to the management interface of the device.

  2. Enter the initial configuration state.

    Press and hold down the MODE button for 6 seconds or longer. When all indicators are steady green, the device enters the initial configuration state.

    The system sets the admin user level to 15 by default.

  3. Configure an IP address for the PC.

    To ensure that the PC and device have reachable routes to each other, configure an IP address on the same network segment with the device IP address for the PC.

  4. Log in to the device through the Web system.

    Open the browser on the PC and access On the displayed Web system login page shown in Figure 5-11, enter the default user name admin and default password, and select the system language. Click GO or press Enter. The Web system configuration page is displayed.

    Figure 5-11  First login page in the Web system

    The first login to the device through the Web system requires that the browser on the PC must be Microsoft Edge, Internet Explorer 10.0, Internet Explorer 11.0, Firefox 53.0 to 59.0, or Google Chrome 54.0 to 66.0. If the browser version or browser patch version is not within the preceding ranges, the Web page may be unable to be displayed normally. You need to upgrade the browser and browser patch.

Updated: 2019-10-21

Document ID: EDOC1000178166

Views: 270902

Downloads: 1993

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next