No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S1720, S2700, S5700, and S6720 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Pre-configured Device Deployment Using an Intermediate File

Pre-configured Device Deployment Using an Intermediate File

On the network shown in Figure 3-9, switches in the dotted box are newly deployed switches with configuration files. The following uses one of these switches as an example to describe how the pre-configured devices are configured using an intermediate file.

Figure 3-9  Networking for pre-configured device deployment
  1. The network administrator plans the physical position, management IP address, management VLAN, and other basic network and service parameters for the switch, and creates a configuration file for the switch.

  2. The network administrator obtains the SNMP host's address and names of files to be downloaded from the intermediate file that has been created offline.

  3. The administrator configures the DHCP server and file server, and then saves the configuration file, the intermediate file, and other files to be downloaded on the file server.

    If the switch to be deployed and the DHCP server are located on different network segments, a DHCP relay agent must be deployed between them.

  4. The device to be delivered has loaded a configuration file that contains commands for specifying file server addresses, name of an intermediate file for site deployment, and a shared key between the device and an SNMP host.

  5. The administrator starts deploying the pre-configured device.

Figure 3-10 shows the interaction between network devices during the pre-configured device deployment process.

Figure 3-10  Interaction between network devices

Pre-configured device deployment goes through four stages:

  1. Apply for an IP address.

    The device to be deployed sends a DHCP request to apply for an IP address. The DHCP server replies with a DHCP response that carries the allocated IP address information.

  2. Obtain file information.

    After receiving the DHCP response, the device to be deployed checks the option field values in the DHCP response to determine whether to obtain file information from the intermediate file.

  3. Download files.

    The device to be deployed downloads the required files from the file server according to the obtained file information in the following sequence:

    1. system software package
    2. patch file
    3. web page file
    4. configuration file
  4. Activate the configuration file.

    Reset the device to activate the file.

If the device to be deployed is a stacked switch, the downloaded system software package, patch file, and web page file are copied from the master switch to standby and slave switches. After the file copy is complete, the device activates the files and then starts to operate normally.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178166

Views: 273304

Downloads: 1996

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next