No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Basic Configuration

S1720, S2700, S5700, and S6720 V200R011C10

This document describes methods to use command line interface and to log in to the device, file operations, and system startup configurations.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Deploying Unconfigured Devices Using an Intermediate File

Deploying Unconfigured Devices Using an Intermediate File

Pre-configuration Tasks

Before deploying unconfigured devices using an intermediate file, complete the following tasks:

  • Configure routing to ensure that the DHCP server, file server, and devices to be configured (have obtained IP addresses) have reachable routes to each other.
  • Collect each unconfigured device's MAC address or ESN by viewing the barcode label on the device.

Procedure

Perform the following operations in sequence.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178166

Views: 256868

Downloads: 1948

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next