No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing Alarms

Clearing Alarms


After alarm messages are cleared, there is no way for the NMS to obtain any information about these cleared messages. Therefore, before deleting alarm messages, be sure that the NMS no longer needs these alarm messages.

In routine maintenance, you can run the following commands to clear alarm messages.


  • Clears hardware alarms.

    • Run clear record device-alarm [ all | slot slot-id ]

      Hardware alarms are cleared.

  • Clearing active alarms.

    1. Run system-view

      The system view is displayed.

    2. Run alarm

      The alarm view is displayed.

    3. Run clear alarm active { all | sequence-number sequence-number }

      Active alarms are cleared.

Updated: 2019-09-23

Document ID: EDOC1000178167

Views: 206327

Downloads: 989

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next