No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Alarm Function for Non-Huawei-Certified Switch Optical Modules

Configuring the Alarm Function for Non-Huawei-Certified Switch Optical Modules

Context

Non-Huawei-certified switch optical modules may fail to work normally. If non-Huawei-certified switch optical modules are used on devices produced after July 1, 2013(January 1, 2016 for QSFP+ 40GE optical modules), the devices generate a large number of alarms to prompt users to replace these optical modules with Huawei-certified switch optical modules. However, vendor information of Huawei early-delivered optical modules may not be recorded. Therefore, non-Huawei-certified switch optical module alarms are generated. These optical modules can still be used to protect customer investment. In this case, you can disable the alarm function for non-Huawei-certified switch optical modules.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run transceiver phony-alarm-disable

    The alarm function for non-Huawei-certified switch optical modules is disabled.

    By default, the alarm function for non-Huawei-certified switch optical modules is enabled.

    To enable the alarm function for non-Huawei-certified switch optical modules, run the undo transceiver phony-alarm-disable command.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178167

Views: 209642

Downloads: 1004

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next