No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
S5710EI Service Port Stacking Support

S5710EI Service Port Stacking Support

NOTE:
  • For the cables that can be used as stack cables, see "Cables" in the Hardware Description. Using other cables may cause exceptions in the stack system, for example, frequent error-down events on stack ports.
  • Combo ports cannot function as stack member ports.
  • For stacking-supported service ports, some of them can be used as stack ports, whereas some can be used as ordinary service ports.
  • The number of stacked switches is recommended to be 2 to 5.
Table 9-13  Service port stacking support

Device Series

Port Supporting Stacking Stack Cable Rate of a Single Port

Remarks

S5710EI Any 10GE ports, including the four fixed 10GE SFP+ optical ports on the front panel and ports on the ES5D21X02S00 rear card (A switch supports a maximum of two rear cards, and each card provides two 10GE SFP+ optical ports.)
  • 1 m SFP+ passive high-speed copper cable
  • 3 m SFP+ passive high-speed copper cable
  • 10 m SFP+ active high-speed copper cable
  • 3 m and 10 m AOC cables (supported in V200R003 and later versions)
  • 10GE SFP+ optical module and optical fiber
10 Gbit/s
  • Any models of the S5710EI series can set up a stack.
  • V200R001: A switch supports a maximum of two logical stack ports, and each logical stack port supports at least one stack member port and at most three stack member ports. A switch supports a maximum of four stack member ports.
  • V200R002 and later versions: A switch supports a maximum of two logical stack ports, and each logical stack port supports at least one stack member port and at most four stack member ports. A switch supports a maximum of eight stack member ports.
  • Ports on different rear cards can be added to the same logical stack port, but ports on a rear card and fixed ports on the front panel cannot be added to the same logical stack port.
Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000178167

Views: 193748

Downloads: 938

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next