No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the Running Status of NTP

Monitoring the Running Status of NTP


After NTP configurations are complete, run the following commands in any view to monitor NTP running status.


  • Run the display ntp-service statistics packet [ ipv6 | peer [ ip-address [ vpn-instance vpn-instance-name ] | ipv6 [ ipv6-address [ vpn-instance vpn-instance-name ] ] ] ] command to view statistics about NTP packets or symmetric peers.
  • Run the display ntp-service status command to view the NTP status.
  • Run the display ntp-service sessions [ verbose ] command to view all session information maintained by the local NTP service.
  • Run the display ntp-service trace command to view the path from the local device to the reference clock source.
  • Run the display ntp-service event clock-unsync command to view causes of the last 10 failed clock synchronizations.
Updated: 2019-09-23

Document ID: EDOC1000178167

Views: 207052

Downloads: 993

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next