No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling/Disabling Stack Traps

Enabling/Disabling Stack Traps


After you enable stack traps on the switch, the switch sends trap messages to the network management system (NMS) when the stack status changes. By default, all stack traps are enabled. You can use commands to disable all or specified stack traps. Then the switch no longer sends these traps to the NMS.

To check the status (enabled or disabled) of stack traps, run the display snmp-agent trap feature-name stack all command.


Disabling the satack traps is not recommended.


  • Enable stack traps.

    Run the snmp-agent trap enable feature-name stack [ trap-name trap-name ] command to enable a specified stack trap or all stack traps.

  • Disable stack traps.

    Run the undo snmp-agent trap enable feature-name stack [ trap-name trap-name ] command to disable a specified stack trap or all stack traps.

Updated: 2019-10-21

Document ID: EDOC1000178167

Views: 209595

Downloads: 1004

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next