No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Stack Connection Modes

Stack Connection Modes

NOTE:

Stack member switches must be directly connected.

Switches can set up a stack through stack card connection and service port connection based on stack port types.

Stack card connection

The following scenarios are supported:

  • Member switches are connected using dedicated stack cards ES5D21VST000 and stack cables.
  • Stack cards are integrated into the rear panels of member switches, and member switches are connected using integrated stack ports and dedicated stack cables.

Service port connections

Service port stacking allows member switches to be connected using service ports, without requiring dedicated stack cards. These service ports are configured as physical member ports and bound to logical stack ports. Figure 9-24 shows physical member ports and logical stack ports in a stack.

Figure 9-24  Service port connections
  • Physical member port

    A physical member port is a service port used to set up a stack link between stack member switches. Physical member ports forward service packets or stack protocol packets between member switches.

  • Logical stack port

    A logical stack port is bound to physical member ports to connect stack member switches. Each member switch supports two logical stack ports: stack-port n/1 and stack-port n/2, where n is the stack ID of the member switch.

Service port connections are classified into ordinary and dedicated cable connections based on cable types.
  • Ordinary cable connection

    Ordinary stack cables include optical cables, network cables, and high-speed cables. When ordinary stack cables are used to set up a stack, logical stack ports must be manually configured. Otherwise, the stack cannot be set up.

  • Dedicated cable connection

    Figure 9-25 shows the appearance of a dedicated stack cable. Its two ends are the master end with the Master tag and the slave end without any tag. When dedicated stack cables are used to set up a stack, switches can automatically set up a stack after these cables are connected to ports according to connection rules.

    Figure 9-25  Dedicated stack cable
Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178167

Views: 207559

Downloads: 995

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next