No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S1720, S2700, S5700, and S6720 V200R011C10

This document describes the principles and configurations of the Device Management features, and provides configuration examples of these features.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling a Port Indicator to Show the Stack ID

Enabling a Port Indicator to Show the Stack ID

Context

The master switch can assign stack IDs to member switches once a stack is established. You can also configure stack IDs for member switches. If stack IDs are assigned by the master switch, it is difficult to match a stack ID with a corresponding member switch. In this case, you can enable a port indicator to show the stack ID of a member switch.

When checking the stack ID of a member switch, note the following:
  • Switch with a stack ID ranging from 1 to 8: The sequence number of the port indicator that is steady on indicates the stack ID of the switch. For example, if the first port indicator is steady on, the stack ID is 1. If the second port indicator is steady on, the stack ID is 2.
  • Switch with stack ID 0: If the first nine port indicators are steady on, the stack ID of the local switch is 0.
  • After port indicators are configured to show the stack IDs, the port indicator of the master switch blinks, and the port indicator of the slave switch is steady on.
NOTE:

On the S5700-28X-LI-24S-DC, S5701-28X-LI-24S-AC, and S5700-28X-LI-24S-AC, if a physical port is shut down by the shutdown command or by the MAD mechanism after the CSS splits, the corresponding port indicator is off and cannot indicate the stack ID of the local switch.

Procedure

  1. Run the stack led enable [ duration duration-value ] command to enable port indicators to show stack IDs of member switches.

    By default, port indicators do not show stack IDs of member switches.

    NOTE:

    This command can be executed only when the MODE button is not pressed on the switch to change the indicator mode.

    The configuration of this command becomes invalid when port indicators show stack IDs of member switches for the specified time.

Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178167

Views: 206030

Downloads: 989

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next