Configuring PoE
Pre-configuration Tasks
Before configuring PoE, complete the following tasks:
- Install the PoE power module and power on it.
- Connect the interfaces on the PSE to PDs to ensure that the status of the link layer protocol of the interface is Up.
Generally, the device can detect whether a PD connected to it needs power supply and provides PoE function. If you need to modify the PoE configuration or manually power on the PD, see the following configuration.
- Enabling the PoE Function
- (Optional) Configuring LLDP Power Capacity Negotiation
- (Optional) Configure the Single-Class Power Supply Mode for
a PoE Interface
- (Optional) Configuring the PoE Power Supply Delay
- Configuring PoE Power Management
- (Optional) Configuring the Device to Allow High Inrush Current
During Power-On
- Configuring PoE Power-on and Power-off Management
- Verifying the PoE Configuration