Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Example for Configuring VLAN ID-based N:1 VLAN Mapping
Networking Requirements
In Figure 11-6, a large number of switches need to be deployed at the corridor so that the same service used by different users can be sent on different VLANs. To save VLAN resources, configure the VLAN aggregation function (N:1) on the switches so that same services are sent on the same VLAN.
Procedure
- Configure the Switch.
# Create a VLAN.
<HUAWEI> system-view [HUAWEI] sysname Switch [Switch] vlan batch 10 100 to 109
# Add GE0/0/1 to the VLAN.
[Switch] interface gigabitethernet 0/0/1 [Switch-GigabitEthernet0/0/1] port link-type hybrid [Switch-GigabitEthernet0/0/1] port hybrid tagged vlan 10 100 to 109
# Configure VLAN mapping on GE0/0/1.
[Switch-GigabitEthernet0/0/1] qinq vlan-translation enable [Switch-GigabitEthernet0/0/1] port vlan-mapping vlan 100 to 109 map-vlan 10
- Verify the configuration.
Verify that users in VLAN 100 to VLAN 109 can connect to the Internet through the Switch.
