No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Typical Networking of the DHCPv6 PD Client

Typical Networking of the DHCPv6 PD Client

Figure 12-14 shows a typical networking of the DHCPv6 PD client.

Figure 12-14  Networking of the DHCPv6 PD client

The DHCPv6 PD client function is configured on the device, the device dynamically obtains IPv6 addresses and other network configuration parameters from the DHCPv6 PD server. This operation facilitates user configurations and centralized management. The device divides the obtained IPv6 prefix (the length of the obtained prefix is smaller than 64 bits) into 64-bit prefix of subnet segments and sends an RA message on the link that hosts directly connect to. The RA message contains 64-bit prefix of subnet segments. This enables hosts to automatically configure addresses.

Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 268887

Downloads: 1024

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next