No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Option Information Requested by a DHCP Client

(Optional) Configuring Option Information Requested by a DHCP Client

Context

The Option 55 field in DHCP Request messages is used to set the request option list. DHCP clients use this option to specify network configuration parameters that need to be obtained from the DHCP server. By default, the Option 55 field carries request options 3, 6, 15, 28, 33, 44, 121, and 184 by default. You can run the dhcp client request option-list exclude command to set a list of default options that are excluded from the Option 55 field.

For option meanings, see DHCP Messages in Configuration- IP Service Configuration Guide - DHCP Configuration.

Procedure

  1. Enter the system view.

    system-view

  2. Enter the interface view or sub-interface view.

    interface interface-type interface-number [.subinterface-number ]

    Only the S5720EI, S5720HI, S6720EI, and S6720S-EI support sub-interfaces.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

    Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

  4. Configure a list of default request options that are excluded from the Option 55 field in DHCP Request messages.

    dhcp client request option-list exclude option-code &<1-8>

    By default, the device does not configure the option to be excluded from the DHCP client request list.

Translation
Download
Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 269107

Downloads: 1024

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next