No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a DHCPv6 PD Server

Configuring a DHCPv6 PD Server

Pre-configuration Tasks

You can configure a DHCPv6 PD server to dynamically assign configuration information such as IPv6 addresses to DHCPv6 PD clients.

Before configuring the DHCPv6 PD server, complete the following tasks:

  • Ensure that the link between the DHCPv6 client and the switch works properly and the DHCPv6 client can communicate with the switch.

  • (Optional) In the scenario where the DHCPv6 relay exists, configure the route between the switch and DHCPv6 relay agent or client.

Configuration Logic

The configuration tasks are performed in sequence.

Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 270606

Downloads: 1025

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next