No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Monitoring the IP Performance Running Status

Monitoring the IP Performance Running Status


In routine maintenance, you can run the following commands in any view to check the running status of IP performance.


  • Run the display icmp statistics command to check ICMP traffic statistics.
  • Run the display ip interface [ interface-type interface-number ] or display ip interface brief [ interface-type [ interface-number ] | slot slot-id [ card card-number ] ] command to check interface-related IP information.
  • Run the display ip socket [ monitor ] [ task-id task-id socket-id socket-id | socket-type socket-type ] command to check information about the created IPv4 sockets.
  • Run the display ip socket register-port command to check non-well-known port numbers that have been assigned to services.
  • Run the display ip socket vcpu vcpuid command to check socket information about the virtual CPU.
  • Run the display ip statistics command to check IP traffic statistics.
  • Run the display load-balance mode [ packet | flow | slot slot-number ] command to check the load balancing mode on a switch.
  • Run the display network status { all | tcp | udp | port port-number } command to check the network status.
  • Run the display rawip statistics command to check RawIP traffic statistics.
  • Run the display tcp status [ [ task-id task-id ] [ socket-id socket-id ] | [ local-ip ip-address ] [ local-port local-port-number ] [ remote-ip ip-address ] [ remote-port remote-port-number ] ] command to check TCP connection status.
  • Run the display tcp statistics command to check TCP traffic statistics.
  • Run the display udp statistics command to check UDP traffic statistics.
Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 268994

Downloads: 1024

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next