No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the BOOTP Client Function

Enabling the BOOTP Client Function

Context

Before a device can function as a BOOTP client, you must enable the BOOTP client function.

After an interface is enabled with the BOOTP client function, the interface can obtain network parameters including the IP address from the DHCP server. If the allocated IP address and IP addresses of other interfaces are on the same network segment, the interface does not use the allocated IP address and does not re-apply for an IP address. To allow the interface to re-apply for an IP address, run the shutdown and then the undo shutdown commands on the interface. Alternatively, run the undo ip address bootp-alloc and then the ip address bootp-alloc commands on the interface.

Procedure

  1. Enter the system view.

    system-view

  2. Enter the interface view or sub-interface view.

    interface interface-type interface-number [.subinterface-number ]

    Only the S5720EI, S5720HI, S6720EI, and S6720S-EI support sub-interfaces.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.

    Only the S5720HI, S5720EI, S6720EI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

  4. Enable the BOOTP client function.

    ip address bootp-alloc

Translation
Download
Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 274527

Downloads: 1029

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next