No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.

Configuration Guide - IP Service
S1720, S2700, S5700, and S6720 V200R011C10

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting the Status of the IPv6 Address Pool

Resetting the Status of the IPv6 Address Pool


When the client addresses conflict due to repeated IPv6 address assignment or IPv6 addresses need to be re-assigned to clients based on the network plan, you can reset the status of the IPv6 address pool. In this way, the IPv6 addresses in the address pool return to the idle state and the clients can re-apply for these IPv6 addresses.


  • Run the reset dhcpv6 pool pool-name [ allocated { address | prefix } | binding [ duid ] | conflict address | ipv6-address [ to ipv6-address ] | ipv6-prefix/prefix-length ] command to clear IPv6 address pool configurations.
Updated: 2020-02-26

Document ID: EDOC1000178170

Views: 273930

Downloads: 1029

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next