No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Network Management Function for RIP

Configuring the Network Management Function for RIP

Pre-configuration Tasks

Before configuring the network management function for RIP, configure basic RIP functions.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rip mib-binding process-id

    RIP is bound to the MIB.

    This command is used to bind a RIP process ID to MIBs and specify the ID of the RIP process that accepts Simple Network Management Protocol (SNMP) requests.

Verifying the Configuration

  • Run the display current-configuration command to view the binding relationships of RIP.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 317271

Downloads: 1114

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next