No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Keychain Authentication

Configuring Keychain Authentication

Context

BGP uses TCP as the transmission protocol, and considers a packet valid as long as the source address, destination address, source port, destination port, and TCP sequence number of the packet are correct. However, most parameters in a packet may be easily obtained by attackers. To protect BGP from attacks, use MD5 authentication or keychain authentication between BGP peers to reduce the possibility of attacks. The keychain algorithm is complex to configure and generates a set of passwords. Keychain authentication allows automatically changing a password based on the configuration. Therefore, keychain authentication applies to networks requiring high security.

NOTE:

Before configuring BGP keychain authentication, configure a keychain corresponding to keychain-name. Otherwise, the TCP connection cannot be established. For details about configuring a keychain, see Keychain Configuration in the S1720, S2700, S5700, and S6720 V200R011C10 Configuration Guide - Security.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bgp { as-number-plain | as-number-dot }

    The BGP view is displayed.

  3. Run peer { ipv4-address | group-name | ipv6-address } keychain keychain-name

    Keychain authentication is configured.

    NOTE:
    • You must configure keychain authentication on both ends of the BGP connection. Encryption algorithms and passwords configured on both ends must be the same; otherwise, the TCP connection cannot be established between BGP peers and BGP messages cannot be transmitted. SHA256 and HMAC-SHA256 encryption algorithms are recommended in keychain authentication.
    • BGP MD5 authentication and BGP keychain authentication are mutually exclusive, and only either of them can be configured for a BGP peer.

    • Only the S5720EI, S5720HI, S6720S-EI, and S6720EI support keychain keychain-name.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 314617

Downloads: 1109

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next