No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Controlling IS-IS Route Selection

Controlling IS-IS Route Selection

Pre-configuration Tasks

Before configuring IS-IS route selection, configure basic IS-IS functions.

Configuration Procedure

You can perform the following configuration tasks (excluding the task of Verifying the IS-IS Route Selection Control Configuration) in any sequence.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 311597

Downloads: 1098

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next