No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Unicast Routing

S1720, S2700, S5700, and S6720 V200R011C10

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, OSPFv3, IS-IS(IPv4), IS-IS(IPv6), BGP, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the BFD for OSPF Configuration

Verifying the BFD for OSPF Configuration

Prerequisites

All configurations of BFD for OSPF are complete.

Procedure

  • Run either of the following commands to check information about a BFD session or BFD sessions:

    • display ospf [ process-id ] bfd session interface-type interface-number [ router-id ]
    • display ospf [ process-id ] bfd session { router-id | all }

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178171

Views: 311717

Downloads: 1102

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next